I sort of pulled a huge dent out of my rocker panel!

First time I’m doing anything body work related and I think I’m not doing that bad at all. I had an enormous dent in the rocker panel of my 1970 Fiat 500 and managed to make it less enormous. I first welded on steel wire loops, but had to use M13 sized washers in the end, and used one of those cheap slide hammers with a little hook.

This is an in between result, I need to spend a little time with one of those tiny hammers to make the panel somewhat more flat and then bondo over it. It’ll probably be noticeable if you specifically look at it but it should be fine at a bit of a distance!