There are 2 bolts with nuts on the end that hold the shock to the hub, you undo these a bit but not fully and then pull or push on the disc and you will see that the disc/hub is able to tilt towards the engine or fall away from the engine. Get a smallish spirit level and place it on front of the disc so its in a vertical position and manoeuvre the hub until the hub is sitting level according to the spirit level reading. if you have no spirit level you can do it by eye. There isn’t too much adjustment there but if you are way out you will see it once the wheels are back on and the car is off the jack. undo the nuts so that they are just lose but easily nipped up in a hurry and the disc will not stay in the position you set it at by hand, so one hand to adjust the disc/hub position and the other hand on the spanner to nip the bolt up, once you’ve done that get the spirit level and see how far out you are. Keep doing this until you get each hub reading level on the spirit level.
Hope this helps. Make sure to post pics once you manage to do it.
you can get around -3,5 degrees by doing it. But don’t forget to get an alignement after that, otherwise your tires won’t last long.
Comments
Hey mate, I used this guide when I did mine:
There are 2 bolts with nuts on the end that hold the shock to the hub, you undo these a bit but not fully and then pull or push on the disc and you will see that the disc/hub is able to tilt towards the engine or fall away from the engine. Get a smallish spirit level and place it on front of the disc so its in a vertical position and manoeuvre the hub until the hub is sitting level according to the spirit level reading. if you have no spirit level you can do it by eye. There isn’t too much adjustment there but if you are way out you will see it once the wheels are back on and the car is off the jack. undo the nuts so that they are just lose but easily nipped up in a hurry and the disc will not stay in the position you set it at by hand, so one hand to adjust the disc/hub position and the other hand on the spanner to nip the bolt up, once you’ve done that get the spirit level and see how far out you are. Keep doing this until you get each hub reading level on the spirit level.
Hope this helps. Make sure to post pics once you manage to do it.
you can get around -3,5 degrees by doing it. But don’t forget to get an alignement after that, otherwise your tires won’t last long.
Camber bolts