3D-printed TPS adapters. (Info in description)

This is my Chaser GX100 throttle body for a Beams 1G-FE VVTi.
Exact same engine as IS200 but different throttle without ETCSi (drive by wire) and sadly a different TPS sensor design. Hence the adapter.
Here is a test fit of my custom 3D printed IACV block off plate and TPS adapter so I can fit the IS200 TPS onto this throttle body. And then fit this throttlebody on my IS200 engine lol

The end goal is to run the engine as shown in the video. Everything disconnected except the main TPS sensor. But with the GX100 throttle I will be able to also operate it using the gas pedal inside the car :)

The engine light will be on but the car will be a lot more fun to drive I recon. If this doesn’t work I might just get a GX100 ECU and harness and do a complete conversion